'Modified' column only shows date

[ron]

Other than in a tooltip, is there a way to have it display the time in the same way BC2 did?

[Michael Bulgrien]

Expand the column from the left side. When it is wider, the time will display with the date.

[Tim]

The timestamp column shows date and time if it fits. It sounds like you need to make your column a little wider.

[ron]

Grrrr, I was pulling on the right hand side. After pulling a bit, but not quite enough, I didn't see anything. I guess I was expecting a partial and therefore ASSumed the data was not there. I'm all better now, thanks

[aquinas]

Me too - but program behavior partly to blame

Even though I have been a “long-time” customer, I too encountered this problem where I thought the "Modified" column was only showing the date, and not the time too. I think this is due to fact that the Time is not shown *at all* until there is enough space to show the *entire* time field. At least this is what I observed in v3.3.1 (build 13971), and what "ron" also experienced.

I would change the program to show some of time stamp whenever there's room enough. Reference attached .ZIP (containing a .PDF) that illustrates what I mean.

I searched the help on this and didn't find anything - a simple entry for this would have saved some aggravation and these posts.

[Aaron]

Thanks for the feedback. Updating how our columns show data is on our Customer Wishlist, and I'll add your notes and example to our entry on the subject.